Available files: Report. It is important to determine the capability of any reinforced soil wall. The expected magnitudes of stresses, failure modes, bearing capacity and displacements should be determined and checked if they are within the allowable serviceability limits provided by design standards. In this paper, both analytical and numerical analysis and design of reinforced […]

Available files: Report and plaxis simulation files. The project involved the sampling of different types of sand soil. These samples were then put into cylinders before they were placed on a vibrating table. The table was used specifically because of its ability to shake the samples and, therefore, instigating the settlement process. The settlement gap […]

Available files: Thesis Report This project involved the determination of the excavation movements’ deformations and stresses in soil structure; their extents, the effects and remedies in the cases of negative effects. Excavation Movements is common in most deep and shallow excavations. It is impossible to ignore this movements due to the effects they have on […]

Available files: Report, HEC-RAS files and Excel Spreadsheet Flow obstruction by bridge piers causes backwater to rise up on the upstream of bridges. This backwater effects may cause flooding and cause havoc on the immediate transport infrastructure such as roads and railway. The backwater effects depend on both flow characteristics as well as geometrical characteristics […]

Available files: Report, PLAXIS simulation files and drawings for the Schmertmann method. Before laying foundation on any type of ground, it is important to determine the expected type and magnitude of settlement in order to ascertain if it is within the set serviceability limit. In this paper, both analytical and numerical analysis of settlement of […]

Available files: Report, codes and simulation files. The energy sector of Bangladesh is highly dependent on fossil fuels. This situation has led to increased carbon dioxide emission over the years. However, the government is strongly advocating for the installation of green renewable energy sources. This has fostered an increased adoption of PV generation systems. The […]

Available files: Report and Matlab Simulink. Water is a very important component required by plants for photosynthesis, good fruit yield, transportation of nutrients, growth, good fruit quality and for maintaining plant quality, raising and stabilizing agricultural yields. Plants obtain their water from the soil through their roots. The soil moisture content is however very variable […]

Available files: Report and codes. In this project, a smart home system that has two functions has been designed and fabricated. The functions of the system are improving security of the home and remote control of appliances. The proposed system is made up of a smoke and gas sensor, an infrared reflective sensor, a water […]

Available files: Report that has Visual Basic codes. For plant growth and development, plants require adequate water, appropriate ambient temperature and humidity levels and adequate amount of light intensity. For this reason therefore many irrigation methods have been developed over the years by man to artificially supply water to the plants. This is because rain […]

Available files: Report that has Matlab codes. Whiteboards were invented to replace chalk boards that posed a health threat to its users due to the chalk dust. Moreover, chalk boards had a smoky appearance after being used for a short period and this distorted the information written on them. In the present times, cleaning of […]

Available files: Report that has Matlab codes. A continuous and uninterrupted power supply is key in the modern day lifestyle and economic activities. Any interruptions of the supply will lead to adverse effects, mostly economical and the effects tend to worsen as the duration of the power disruption/outage increases. Thus, a system that can monitor […]

Available files: Matlab Simulink and Report. In this project, a system has been designed, modelled and simulated for the speed regulation of a separately excited DC motor under dynamic conditions of reference speed and mechanical input toque. The DC motor is supplied from a DC source through a chopper that is made up of a […]